MFE and MAE explained

The best and worst a trade did while it was open, and how to use them to judge your stops and targets.

The short version

MFE is Maximum Favorable Excursion: the most open profit a trade showed at any moment, from entry to exit. MAE is Maximum Adverse Excursion: the most open loss it showed.

Your final P&L is one number. MFE and MAE show the path the trade took to get there.

A worked example (example numbers only)

You go long 1 NQ contract. After entry the price drops 6 points against you (MAE = 6 points, or 120 at 20 per point). Then it rises 25 points above your entry (MFE = 25 points, or 500). You exit 12 points above entry and bank 240.

So the trade hurt by 120 at worst, was worth 500 at best, and you kept 240.

Reading MAE: are your stops sensible?

  • If your winning trades rarely go far against you, a tighter stop may have cost you nothing. If they often dip close to your stop before working, your stop may be doing its job, or it may be too tight.
  • If your losing trades show MAE much bigger than your planned stop, your stop was not respected. That is a rule problem, not a market problem.

Reading MFE: are your exits sensible?

  • Compare MFE with what you banked. A trade that ran 500 in your favour and closed for 40 gave back most of it.
  • Capture rate is profit divided by MFE. A low capture rate across many trades can mean you exit too early, or hold winners until they turn. The number alone does not say which.
  • If most trades never reach your target, the target may be too far for that setup.

What MFE and MAE cannot tell you

  • They show what already happened. They do not predict the next trade.
  • You need many trades before a pattern means anything. A handful can mislead.
  • They depend on the price data behind them. Intraday data can be rounded to bars, so treat small differences as noise.
  • Hindsight bias: the best exit looks obvious only after the fact. Use MFE to review your rules, not to blame a single trade.

How Tradeopath shows this

  • For recent closed futures trades, Tradeopath computes MFE and MAE from 1-minute price bars between your first and last fill. It follows your fills, so scaling in or out is taken into account, and it gives both dollars and points.
  • The numbers are approximate. The price bars come from Yahoo’s continuous-contract data, and the entry and exit bars can include price action outside your holding time. They are shown with an approximate sign.
  • Open a trade to see MFE, MAE and Capture (profit as a share of MFE). Reports has an R-multiple card with Capture rate, Avg MFE and Avg MAE.
  • A small line appears while recent closed trades still lack MFE and MAE, with a button to compute them. Forex and CFD trades, and instruments without a dollar-per-point value, are not computed.

This guide is education, not financial advice. Examples use made-up numbers. Firms and platforms set their own rules and can change them, so always read your own. Trading involves risk of loss. Risk disclaimer

Related

Back to the help center